This is a DIY Flipper Zero-style multi-tool running on Raspberry Pi Zero 2.
Run the app on your Pi in BASH: cd flipperpi/web python3 app.py Then visit http://:5000 from any device on the same network.
INSTALLATION & HARDWARE SET-UP
FLASH RASPBERRY PI OS LITE:
Download Raspberry Pi Imager: https://www.raspberrypi.com/software/
OS: Raspberry Pi OS Lite (64-bit) Storage: Your microSD card
Click the gear icon in Imager: Enable SSH Set Wi-Fi SSID & Password Set hostname: flipperpi
Flash the card and insert into your Pi.
FIRST BOOT:
Power on the Pi Zero 2 W Defauly Passs: raspberry
Connect via SSH from your PC EX. PowerShell: ssh pi@flipperpi.local
Update system in BASH: sudo apt update && sudo apt upgrade -y
INSTALL REQUIRED PACKAGES:
Install Python & Flask in BASH: sudo apt install python3 python3-pip git -y pip3 install flask spidev mfrc522
If you are using an RF CC1101 module via SPI, in BASH: sudo raspi-config Then Enable SPI, I2C (NFC reader requirement). Reboot once changed.
DEPLOY THE FLIPPERPI PROJECT:
In your host PC: EX. PowerShell: scp -r flipperpi_project_full pi@flipperpi.local:/home/pi/
In the PI BASH: cd ~/flipperpi_project/flipperpi/web python3 app.py
TEST THE WEB UI:
On your host PC's browser: http://flipperpi.local:5000
Enter the PIN you set in app.py (default: 1234)
Try pressing: HID attack - Executes hid_keyboard.py RF send - Executes cc1101_send.py NFC read - Runs nfc_reader.py USB storage toggle - Runs usb_storage_toggle.py
SET FLASK TO RUN AT BOOT:
In PI BASH: sudo nano /etc/rc.local
Before the exit 0 line, add: python3 /home/pi/flipperpi_project/flipperpi/web/app.py &
Save and reboot: sudo reboot